Rewiring a Motion Sensor Light in 6 Simple Steps

A motion sensor is a device that converts the detection of motion into electricity. Whenever it senses any motion taking place it turns the lights on automatically. If this fails to happen then your motion sensor light needs to be rewired. The rewiring of a motion sensor light is easy if you carry out the proper procedure and preserve safety.
  1. The first and the most common step is to turn the circuit breaker off from the central board.
  2. Now switch on the light and check whether it is on or off with the help of a tester. The tester will light if the sensor is still on. Carry on with the process ones you are sure that the sensor is off.
  3. Take a screwdriver and remove the junction box plate. Ones the junction box is taken off twist the wire nuts.

Learn the Procedure of How to Install a Light Timer

Light timers are guides that help you find out the heavy-duty lights that are kept on in your house. Keeping light on unnecessarily can result in a tremendous loss of energy. Installing light timers can ensure that the lights are turned off and help in saving a lot of precious energy. Installing a light timer in your house is an extremely easy and trouble-free process to perform.
  1. First step is to turn off the main switch from the circuit breaker.
  2. Take a screwdriver and unscrew the faceplate of the light switch. Remove the plate out and check whether the electricity is not been passed with the help of a tester.
  3. If the electricity is off then carry on with the process. Remove the wire connectors by unscrewing the old lights from the walls. This way the lights will be disconnected.

How to Join Two Telephone Cables

You must have seen houses where there are two telephone lines attached. If you are wondering how this can be possible, then i give you the answer. This is possible with the use of a RJ11 coupler. RJ11 coupler is a connector on the conclusion of the phone cable. You can connect two RJ11 cables to get two different phone lines. Its application is extremely simple:
  1. First take one phone line and connect it to one of the RJ11 ports on the coupler.
  2. Now connect the other end of the phone line to the wall jack.
  3. Now take the second phone line and connect it to the other RJ11 slot on the coupler.
  4. Connect the other end of the line to the RJ11 port on the phone. Your connection is complete.

How to Reseat USB & Power Cables

Re-seating a USB or a power cable is an easy task to do. USB or power cables are the equipments that attach you’re the peripheral equipment, such as computers, hard drives, printers, modems, cameras, etc. to its power supply. These power cables become loose, so it is important to check them form time to time. If these cables become loose, your equipment will not work. Some precautions needs to taken before re-seating a USB or a power cable.
  1. Firstly, shut down or switch off the equipment to which the cable is attached.
  2. Take out the plug out of the socket slowly by switching the power switch off.
  3. Now properly insert the cable back into the power socket. Make sure that the plug is fully inserted into the socket.

How to Troubleshoot Electric Motor Starters

If your electric motor starter is facing problems then its troubleshooting can be a problematic task. But ones you have thoroughly understood its basics then troubleshooting can be done without mush trouble. Follow these steps to troubleshoot an electric motor starter:
  1. The first step to perform is to wear safety glasses and switch off all the connections. Take all the precautions before starting the troubleshooting. Switch off the volt-ohm meter to volts and place the leads to the incoming power. The voltage should read 0.
  2. Check that all the screws are tight with the help of a screwdriver. Also heck the wires for any burnt or black discoloration. If so, then immediately replace the wires with a new one.